User Tools

Site Tools


layerlines

This is an old revision of the document!


Layer lines:

Cause:

  • Cause #1:

Heater heating cycles of the heater causing the resin the shrink and expand during the print, making uneven surfaces.

  • Cause #2:

The orientation of the print combined with not enough supports is not Ideal.

Solution:

  • Option#1:

test run with turning off the heater will confirm the cause, the problem happens usually with users live in cold-weather regions, better heat-loss protection for the Moai will most likely fix the problem (this is based on user’s result).

  • Option #2:

Make sure the densest part of the model is on the build plate facing towards the red, put model at 45-degree angle towards the green side of the plate in asura.

Make sure there are ample supports to hold the structure of the part during the riggers of printing.

layerlines.1568656048.txt.gz · Last modified: 2019/09/16 12:47 by peopoly