This is an old revision of the document!
Regular checkup after you have used Moai over an extended period to ensure optimal performance and latest settings.
Hardware check up
Z-Axis and Build Platform
Please check these screws. 8 on the Build Plate Arm, 2 on z-axis from the front side. 6 on the build platform that is holding the vat. (3 on each side)
From the back of the machine, double check to make sure Z-axis is mounted securely by checking these 8 screws
You can also use common engine oil like 5w-30 to lubricate the Z-axis rod.
Check these 6 screws to make sure they are fully tightened, and the metal rod is locked. This is what you will see when looking in from the left frame side:
Make sure these parts of platform are secured too
Check the PM motor and see if it is secured mounted:
Also check these screws and see the rod in the PM motor is straight. DO NOT use engine oil to lubricate PM motor!
Check the acrylic cover and galvo mirrors and make sure they are not dusty or covered
Laser and Galvo position
Check the laser / galvo and see if they are mounted in the correct position. The tip of laser head should be flat on the fixture, not sticking out and sunk in. Please also make sure both X/Y Galvos are pushed in all the way in their sockets.
You learn about how to adjust their positions in the advanced calibration guide
System Check Up
Update Firmware update to the latest please visit Moai Firmware Update guide
Make sure Setting is the latest: Current Settings and Profiles
Make sure your Cura is the latest by uninstall, cleaning and then update to the latest Cura at Moai Wiki on Software
Check Leveling using our improved Leveling Guide.
If you find your prints are distorted on the X/Y plane, please follow advanced calibration guide
Printing and Post Processing
Make sure your printing temperature is at least 20C (68F) and ideally 25C (77F). You can learn more about resin's properties and best ways to clean and cure here in the Moai Resin Wiki
We have made numerous update to software recommendation. For advanced users, B9 is a great tool, and XYZware / Flashforge offers great software for automatic support generation. For more information, check out the Moai Software Wiki.