User Tools

Site Tools


moai-hardware

This is an old revision of the document!


Moai Hardware

Specification

  • Physical Size: 30 x 30 x 63 cm
  • Print Volume: 13 x 13 x 18 cm
  • Weight: 15 kg
  • Laser Type: 405nm UV LED laser
  • Laser Power: 150mW
  • Slicer: Cura 2.6 Moai
  • Operating System: Windows, OSX, Linux
  • Power Input: 100-240V 50/60Hz 2.0A
  • Power Requirement: 24 V - 2.5A
  • Processor: 32 bit ARM processor
  • Print Format: Gcode
  • Shipping Size: 75 x 45 x 30 cm
  • Shipping Weight: 21 kg

Hardware Installation Manual: https://drive.google.com/open?id=1yzSxYxJ2hDWH5Tks4eD-P5XpEBOaRhRxpic4mbyX3ks

leveling https://drive.google.com/open?id=1MeXCjGVIVvCN8XrciehLLfmdflCe3DazT6CqE1-7oew

Advance Moai calibration guide: https://drive.google.com/open?id=17EYM9WTy9HMLh6x3lLFIOnQ_dxqDnTRWgukOVBkIxvg

Latest firmware https://drive.google.com/open?id=0Bzke6lBHG_z5VzVUX2JfMGNIOHM

z-axis check https://forum.peopoly.net/t/check-your-z-axis-screws-for-build-plate-arm/214

z-axis accuracy check Without the base, the cylinder is 30mm high https://drive.google.com/open?id=0Bzke6lBHG_z5dllYZnhURXdJWEU

Moai printables add-on https://www.thingiverse.com/groups/peopoly-moai/things

moai-hardware.1510911810.txt.gz · Last modified: 2017/11/17 03:43 by peopoly