User Tools

Site Tools


moai-printing

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
Next revision
Previous revision
moai-printing [2017/11/18 00:32]
peopoly
moai-printing [2017/11/28 05:49] (current)
peopoly
Line 10: Line 10:
 steps: steps:
   * repair the model from any defects (Meshmixer)   * repair the model from any defects (Meshmixer)
-  * rotate the model to an orientation that will meet printing goal (success rate+  * rotate the model to an orientation that will meet printing goal (success rate
   * hollow (can save resins but not necessary) and drain holes   * hollow (can save resins but not necessary) and drain holes
   * add support (Meshmixer, B9)   * add support (Meshmixer, B9)
Line 24: Line 24:
   * ]]   * ]]
   * [[https://​www.youtube.com/​watch?​v=6U11vTZNrTw|Ron'​s support video]]   * [[https://​www.youtube.com/​watch?​v=6U11vTZNrTw|Ron'​s support video]]
 +  * [[https://​www.youtube.com/​watch?​v=iZ2GKZtTkKE|Ron'​s hollow video]]
   * [[https://​peopoly.net/​blogs/​news/​moai-work-flow-print-orientation|Workflow via B9Creator]]   * [[https://​peopoly.net/​blogs/​news/​moai-work-flow-print-orientation|Workflow via B9Creator]]
- 
  
 Preparation of Moai Preparation of Moai
moai-printing.1510986740.txt.gz ยท Last modified: 2017/11/18 00:32 by peopoly