This shows you the differences between two versions of the page.
|Both sides previous revision Previous revision||Last revision Both sides next revision|
moai-sdcard [2018/06/14 10:25]
moai-sdcard [2018/12/19 07:50]
|Line 13:||Line 13:|
|==== Forum Post ====||==== Forum Post ====|
|-||It is best to save gcode to harddrive and copy directly to the sd card’s Gcode directory. Don’t delete or move any files. If you want to start a big print, reformat using SD formater and print.||+||It is best to save gcode to hard drive and copy directly to the sd card’s Gcode directory. Don’t delete or move any files. If you want to start a big print, reformat using SD formater and print.|
|-||We believe we have found the problems for this in firmware and SD card reader, but it will take some time to address. Please use above method until fixed.||+||Use a name other than "gcode" for your directory and do not nested subdirectories. We use "print" in our lab and has worked pretty well.|