User Tools

Site Tools


moai:galvocalibration

This is an old revision of the document!


Galvo Calibration

This step is just to make sure that the hardware is installed correctly and the laser fires where its supposed to. The Moai is shipped with galvos and plate calibrated together, this is the first test to ensure that nothing happened during shipping.

1. Power On

  1. Press the Power key in the front
    1. The PM Motor will make a loud noise as it tilts the vat and lowers it
    2. The Z Motor will raise to the very top of the rod and then lowers just a bit before stopping
  2. You should see the Ready screen when those are complete
moai/galvocalibration.1512751486.txt.gz · Last modified: 2017/12/08 10:44 by ronusmc