User Tools

Site Tools


moai:galvocalibration

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
moai:galvocalibration [2017/12/08 10:44]
ronusmc
moai:galvocalibration [2017/12/08 11:14] (current)
ronusmc
Line 4: Line 4:
  
 ===== 1. Power On ===== ===== 1. Power On =====
-  ​Press the Power key in the front+  ​Press the Power button ​in the front
     - {{:​moai:​powerbutton.png?​direct&​200|}}     - {{:​moai:​powerbutton.png?​direct&​200|}}
     - The PM Motor will make a loud noise as it tilts the vat and lowers it     - The PM Motor will make a loud noise as it tilts the vat and lowers it
     - The Z Motor will raise to the very top of the rod and then lowers just a bit before stopping     - The Z Motor will raise to the very top of the rod and then lowers just a bit before stopping
-  - You should see the Ready screen when those are complete + 
-    - {{:​moai:​menu-home.png?​direct&​400 |}} + 
-  - +  * You should see the Ready screen when those are complete. If your firmware is old, [[moai:​firmware|please upgrade]] first. 
 +    - {{:​moai:​menu-home.png?​direct&​400|}} 
 + 
 + 
 +  ​* Use the Control Knob above the power button 
 +    * {{:​moai:​knobinstructions.png?​direct&​400|}} 
 + 
 +  * Enter Setup and verify settings and firmware. If your firmware is old, [[moai:​firmware|please upgrade]] first. 
 +    * {{:​moai:​currentsettings.png?​direct&​400|}} 
 + 
 +  * Download the [[https://​drive.google.com/​open?​id=0Bzke6lBHG_z5MkhwQjZ0bk5UaXM|Circle Marking page]] and the [[https://​drive.google.com/​open?​id=0Bzke6lBHG_z5NmdFUmZENDZ0OEk|Circle Marking gcode]] 
 +    * Print out the Circle Marking Page at 100%, cut it out and place inside your vat. Orient it correctly. 
 +    * Extract ''​P_yuan-test.gcode''​ from the Circle Marking gcode file you just downloaded and put it in a folder named ''​gcode''​ on an SD Card 
 +    * Insert SD Card into machine 
 + 
 +  * Select Print and press the Control Knob one time 
 +    * {{:​moai:​menuprintready.png?​direct&​400|}} 
moai/galvocalibration.txt · Last modified: 2017/12/08 11:14 by ronusmc