User Tools

Site Tools


moai:layerchange

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

moai:layerchange [2019/08/14 08:55] (current)
peopoly created
Line 1: Line 1:
 +How does layer change work? What are the mechanics of it? This page will answer those questions. ​
  
 +====== Layer Change Actions ======
 +
 +
 +At each layer change, these actions happen:
 +
 +1. laser stop
 +
 +2. PM motor starts to tilt the vat downward, based on //PM Reset// distance (the length of peel) at //PM Moto speed//
 +
 +3. at the same time of "​2",​ if //Z Follow// is not zero, the build plate will move down at the distance of //Z Follow// and at the speed of //Z Moto Speed//.
 +
 +4. PM Motor reaches to the specified //PM Reset// distance and start to move back
 +
 +5. As step "​3"​ is completing, the build plate goes back to the current layer position. Then it moves up to the next layer (depends on layer height).
 +
 +
 +=== Points to consider ===
 +
 +
 +  * If PM Reset distance is too short, then the print is not completely separate from the fep film (because resin sticks and pulls the film up). This is the most common failure for fep vat. That is why fep vat's pm reset distance is recommended to be at least 40.
 +
 +  * If Z Follow is too large or //Z Motor// speed is too fast. Depending on the combination,​ the build plate can either slam the print into the vat, leading to print failure
 +
 +  * If Z Follow is too large or //PM Reset// is too small, the vat can also slam into the print as the build plate is still doing //Z Follow// while pm motor already returning to its default position
moai/layerchange.txt ยท Last modified: 2019/08/14 08:55 by peopoly