User Tools

Site Tools


moai:levelingnewplate

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
moai:levelingnewplate [2018/08/03 10:50]
lyndondr
moai:levelingnewplate [2018/08/10 04:02] (current)
peopoly
Line 7: Line 7:
 {{:​moai:​plate-m3.jpg?​nolink&​600|}} {{:​moai:​plate-m3.jpg?​nolink&​600|}}
  
-The printing side of build plate is not oxidized to improve adhesion. ​+The printing side of the build plate is not oxidized to improve adhesion. ​
  
 {{:​moai:​plate-surface.jpg?​nolink&​600|}} {{:​moai:​plate-surface.jpg?​nolink&​600|}}
 +
 +
 +----
  
  
Line 44: Line 47:
 7. To check level, run DIY-Test and see if all corner pegs have a length between 10.0 to 10.9mm. If so, your Moai is leveled and ready to print. If not, repeat from step 1. (Do not attempt to adjust the screws under vat platform when using easy to level build plate) 7. To check level, run DIY-Test and see if all corner pegs have a length between 10.0 to 10.9mm. If so, your Moai is leveled and ready to print. If not, repeat from step 1. (Do not attempt to adjust the screws under vat platform when using easy to level build plate)
  
-*FEP vat has a wider tolerance than a PDMS vat+Leveling Note for FEP vat
 +Because FEP vat is more durable than PDMS, it can handle ​much wider varience in plate pressure (represented by peg height). A 10.3mm peg height would be fine on FEP vat yet could shorten the lifespan of a PDMS vat
 + 
 + 
 +----
  
-- 
  
 ===== For PDMS vat ===== ===== For PDMS vat =====
Line 76: Line 82:
 {{:​moai:​plate-pdms-1878.jpg?​nolink&​400|}} {{:​moai:​plate-pdms-1878.jpg?​nolink&​400|}}
  
-7. To check level, run DIY-Test and see if all corner pegs have a length between 10.6 to 10.9mm. If so, your Moai is ready to print. If notyou can repeat from step 1. (Do not attempt to adjust the screws under vat platform when using easy to level build plate)+7. To check level, run DIY-Test and see if all corner pegs have a length between 10.6 to 10.9mm. If so, your Moai is ready to print. ​The user can increase z-reset to reduce the corner pegs height as needed without releveling.  ​If the deviation between the pegs is too wide (ex one peg is 10.5mm and the other peg is 1mm)please ​repeat from step 1.  
 + 
 +**(Do not attempt to adjust the screws under vat platform when using easy to level build plate). ** 
  
  
  
moai/levelingnewplate.txt · Last modified: 2018/08/10 04:02 by peopoly