User Tools

Site Tools


phenom:selfsupportguide

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Next revision Both sides next revision
phenom:selfsupportguide [2020/01/19 04:47]
peopoly created
phenom:selfsupportguide [2020/01/19 05:05]
peopoly
Line 26: Line 26:
  
 Printing Printing
-P1. What resin?//+P1. What ​type of resin?//
  
 +Resin plays a big role in the printing success rate. Each resin has a different ability to withstand the peel force and stick to the build plate. While Phenom allows users to set custom exposure settings, many of the resins on the market are untested, so when in doubt or if you are new to resin printing, stick with Deft resin. ​ Resins made for laser SLA or DLP printers are also unlikely to work for Phenom even if it is designed for 405nm light source. And lastly, many resins designed for small format LCD/MSLA printers released too much heat and can degrade LCD lifespan quicker than expected. ​
  
-2. What software to slice and generate support? + 
-3. What exposure profile? ​ What is the layer height, Layer exposure time? Bottom Layer Exposure Time, Life distance. +---- 
-4. Does print stick to the plate? Or does it break off halfway? Please describe if print fails + 
-5. Share your model setup screenshot?​ + 
-6. What is the wall thickness?​ +2. What software to slice and generate support?// 
-7. How many drain holes? +3. What exposure profile? ​ What is the layer height, Layer exposure time? Bottom Layer Exposure Time, Life distance.// 
-8. What is the environment temperature?​ Is there a heater setup? +4. Does print stick to the plate? Or does it break off halfway? Please describe if print fails// 
-9. Does the printer make loud noise during layer change+5. Share your model setup screenshot?// 
 +6. What is the wall thickness?// 
 +7. How many drain holes?// 
 +8. What is the environment temperature?​ Is there a heater setup?// 
 +9. Does the printer make loud noise during layer change//
  
  
  
phenom/selfsupportguide.txt · Last modified: 2020/05/10 04:20 by peopoly